0 of 25 Questions completed
Questions:
You must fill out this field. |
|
You must fill out this field. |
|
You must fill out this field. |
|
You must fill out this field. |
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading…
You must sign in or sign up to start the quiz.
You must first complete the following:
0 of 25 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
What are the goals of this course?
Identify an Employer responsibility under the Alberta OH&S Act.
Identify an Employee responsibility under the Alberta OH&S Act.
If an imminent danger exists to the worker while performing a task. The worker must:
Who should attend tail gate meetings:
The purpose of a pre-operational inspection is to:
If an operator discovers a broken piece of equipment, he must:
A safe operating zone is approximately ________ time(s) the length of the equipment?
Power Mobile Equipment may have:
PME with 3 point contact, plus a fourth point located near the top of the equipment is said to have the stability shape of a:
When equipment is stationary (not moving), it is said to be in the state of:
Which is correct for traveling up an incline with a load?
Which of the following are correct for traveling down an incline without a load?
When reading load charts, it is important to know:
The International Industrial Truck Association recognizes ____ classes of lift trucks?
The operator is standing when operating these classes of lift trucks:
Lift trucks are intended to withstand the forces involved with:
Lift trucks can weigh between:
The lift truck is most stable while ______, _______, with the load low to the ground and _______ the truck.
When a lift truck is at its’ maximum reach, the attachment will be at its’ __________point ___________the nearest fulcrum.
Side slopes have a serious effect on the __________ stability of a lift truck.
When working on smooth terrain, the lowest point of the attachment or load should be ___________ inches above the ground’s surface.
If the operator is expected to move hazardous materials, the employer should not develop specific company procedures to ensure the safe handling of these loads.
The amount of load required to upset a lift truck is known as the: